NXG Technology NX-RM505 - Manual (Page 34)

8. Erasing Existing Programming
A. Erasing Learned Buttons
1 Go to the SETUP mode by pressing both the MAIN and ENTER
buttons simultaneously for three seconds.
2 Press the ERASE button next to the LCD screen.
3 Press the LEARN button.
4 If you wish to erase all the learned functions in the NX-RM505 ,
press the ALL button and then press the SURE? button at the next
LCD screen.
5 If you wish to erase all the buttons in a single device or an individual
button in the device, press the Device button.
6 Press the device button (TV, VCR, Audio, etc.) to erase the button(s)
from the device.
Tip: Press the PAGE button and then press the DEVICE button
(TV, VCR, Audio, etc.) to erase the learned function in the
device button itself. Programming this learned function to the
Device button was explained in ‘Programming the Ten Device
Buttons’ earlier.
7 Press the ALL button if you wish to erase all the learned buttons in
the device and press the SURE? button at the next LCD screen.
NX-RM505
34
NX-RM505_Remote_Manual 10/6/08 6:17 PM Page 34