NXG Technology NX-RM505 User Manual
Page 23
4. Programming the NX-RM505 to Control Your
Components
7
Once you complete the programming and wish to exit the
Learning mode, press the MAIN button. Exit from the SETUP
mode by pressing the MAIN button once again.
Tip: Only follow these instructions if you actually want a code sent when
changing devices. Some users do not want a Device to send out a code
when changing to that device.
For example: You program the AMP’s TV input code on the TV
device and are in the DVD device pages because you are controlling
the DVD player. The AMP's input is set to DVD. Now you want to
quickly adjust the picture on the TV. If you push the TV Device
button, it will change the input on your AMP to TV and you will not
be able to adjust the picture for your DVD. In this case, it would be
better not to program a code to the TV device. However, your
circumstances may be different.
NX-RM505
23
NX-RM505_Remote_Manual 10/6/08 6:17 PM Page 23