NXG Technology NX-RM505 - Manual (Page 37)

8. Erasing Existing Programming
2. Erase Macro Functions In The Ten Device Buttons
1 Go to the SETUP mode by pressing the MAIN and ENTER buttons
simultaneously for three seconds.
2 Press the ERASE button next to the LCD screen.
3 Press the MACRO button.
4 Press the KEY button.
5 Press one of the ten DEVICE buttons from which you wish to erase
the macro function and then press the SURE? button at the next LCD
screen.
6 Exit from Macro mode by pressing the MAIN button and then exit
from SETUP mode by pressing the MAIN button once again.
D. Erasing Punch Through Functions
1 Go to the SETUP mode by pressing the MAIN and ENTER buttons
simultaneously for three seconds.
2 Press the PUNCH button next to the LCD screen.
NX-RM505
37
NX-RM505_Remote_Manual 10/6/08 6:17 PM Page 37