Extron Electronics VSC 900_900D User Guide - Manual (Page 48)

Appendix, cont’d
VSC 900/900D • Appendix A-8
7. Insert the card’s installation screw through the SDI card’s mounting hole
and gently tighten it into the standoff.
8. Install the SDI connector’s hex nut and keep the SDI card from twisting as
the nut is tightened.
9. Replace the top cover on the VSC, and fasten it with the screws that were
removed in step 3.
10. Rack/furniture mount the scan converter, connect the input/output cables,
and reconnect the AC power cord.
20-pin socket on
back of SDI card
20-pin connector
on main board