Extron Electronics VSC 900_900D User Guide - Manual (Page 25)

2-17 VSC 900/900D • Installation and Operation
Image Frozen
Controls Locked
Extron VSC 900
Scan Converter
2 sec.
2 sec.
Horiz. 56.19 KHz
Vert. 49.95 Hz
FREEZE/
RESET The Freeze/Reset button may be pressed
at any time and from any menu to freeze the
image. Press again to unfreeze the image.
Figure 2-19 — Freeze function
Unit reset function
To reset the VSC to the factory default settings, press and hold the Freeze/Reset
button for about two seconds until the Freeze/Reset LED begins to blink, then
immediately press the Menu button to reset the VSC to factory defaults. If you
wait too long before pressing the Menu button, the freeze mode will be enabled.
You will need to press the Freeze/Reset button a second time to disable the freeze
mode.
MENU = Factory
NEXT = Input #
Unit
Reset
Extron VSC 900
Scan Converter
2 sec.
2 sec.
Horiz. 56.19 KHz
Vert. 49.95 Hz
FREEZE/
RESET To reset the VSC to factory default settings, press and hold the Freeze/Reset
button for two seconds (the LED will begin to blink). Immediately press the Menu
button to reset the unit. If you wait too long before pressing the Menu button, the
freeze control will be activated and the Freeze/Reset button must be pressed again
to unfreeze the controls.
MENU
Figure 2-20 — Unit reset function
Input reset function
To reset the VSC’s active input to the factory default settings for centering, sizing,
and zooming, press and hold the Freeze/Reset button for about two seconds
until the Freeze/Reset LED begins to blink, then immediately press the Next
button to reset the active input to factory defaults. If you wait too long before
pressing the Next button, the freeze mode will be enabled. You will need to press
the Freeze/Reset button a second time to disable the freeze mode.