Extron Electronics VSC 900_900D User Guide - Manual (Page 29)

2-21 VSC 900/900D • Installation and Operation
VSC Infrared Remote Control
The VSC IR remote control, shown at
right, replicates all of the front panel
controls except the Menu, Next, and
Cursor buttons. If executive mode has
been enabled on the VSC, input
selection and adjustments can still be
made from the remote control or the
Windows-based control program (via
an RS-232 device) to configure the
video scan converter. See chapter three,
“Serial Communication”, for details.
The topmost part of the remote control
features a Freeze On/Off button. The
Horizontal (Horiz) and Vertical Filters
buttons are nonfunctional. The Inputs
buttons will select either Inputs 1 or 2.
The middle portion of the VSC remote
control features the Size and Shift
buttons. The Size buttons are used to
size an image and the Shift buttons are
used to center an image.
The bottom portion of the remote
control features Presets 1 - 8. The
presets will save the input rate, sizing,
and centering information. After
properly setting up an image, press the
Store button, then select and press a
Preset button to save the settings to that
selected preset button. To retrieve a
preset, select the desired Preset button.
Use the Zoom button to zoom in and
zoom out of an image.
The preset feature is available
through RS-232 commands,
VSC front panel controls, and
the IR remote.