Extron Electronics VSC 900_900D User Guide - Manual (Page 20)

Installation and Operation, cont’d
VSC 900/900D • Installation and Operation 2-12
If you press the Menu button while a submenu is active, the next main menu
will become active. For example, the menu will change from the Auto
Imaging submenu to the Output Configuration main menu.
To return to the default menu cycle, let the VSC time-out for 10 seconds, or
press the Menu button until the Exit Menu menu appears, then press the
Next button.
Output Configuration menu (Output Config)
The following flowchart provides an overview of the Output Configuration
menu.
Output
Config
Output
RGBHV
NEXT
Press NEXT to
Auto Image
NEXT NEXT
Standard
NTSC
NEXT
No Input
Black Video
NEXT
Sync formats
• RGBHV (default)
• RGBs
• RGsB
• Component (R-Y, Y, B-Y)
Setup PAL
On
Setup NTSC
Off
Standard
• NTSC (default)
• PAL
Display screen if no
input
• Black Video (default)
• Color Bars Set PAL pedestal on or off.
• On
• Off Set NTSC pedestal on or
off.
• On
• Off
MENU
Figure 2-12 — Output configuration menu
Output signal submenu (Output)
The VSC will simultaneously output RGB or component video, composite video,
S-video, and SDI component (VSC 900D only). The RGB type must be selected
from this submenu.
Use the Cursor buttons to select from among the following sync formats:
• RGBHV (default) • RGsB
• RGBS • Component
Video standard submenu (Standard)
The VSC offers a choice of video standards. Use the Cursor buttons to select from
between the following video standards:
• NTSC (default) • PAL
Set NTSC pedestal submenu (Setup NTSC)
The pedestal for NTSC video format may be turned on or off. See the following
note. Rotate the horizontal Adjust knob (
) or vertical Adjust knob ( ) to turn
the pedestal on or off.