Extron Electronics TP Transmitters User Guide - Manual (Page 30)

Extron TP Transmitters • Specifications, Accessories, and Part Numbers Extron TP Transmitters • Specifications, Accessories, and Part Numbers
Specifications, Accessories, and Part Numbers, cont’d
2 - BNC
Blank Plate (no connector)
Single Space
Double Space
Blank Plate (no connector)
5 - BNC (Double)
2 - RJ-11
1 - 3-pin XLR Connector
2 - RCA to Solder Cups
3 - RCA to Solder Cups
2 - S-video
2 - F Connectors
1 - D-9 Pass Through Connector
1 - HD-15 Pass Through Connector
2 - 1/4" Stereo Phono
2 - 3.5mm Stereo Mini
3 - BNC
Figure A-1 — Architectural adapter plates
TP T 468 Template
The following template is actual size. It also includes the
recommended 0.1" (0.25 cm) clearance on all sides of the
electrical wall box to allow room for raised area surrounding the
knockout.
The dashed line on the template indicates the cut-out area for
installing a wall box. If you plan to install the TP T 468 without
a wall box, use the smaller cut-out area indicated by the dotted
lines.
Use the following template as a guide for cutting a hole in a
wall or furniture for the 4-gang size electrical box in order to
install the transmitter.
A-12 A-13
The light g
ra
y area represents the la
y
out of the electr
ical bo
x
(3.75" H x 7.38"
W / 9.53 cm H x 18.75 cm
W)
against the rear of the
TP
T 468 front panel.
The dashed line indicates the cut-out area: (3.95" H x 7.58"
W / 10.03 cm H x 19.25 cm
W)
for installing the electr
ical w
all bo
x.
T
o
install the interf
ace
without
a w
all bo
x,
use the cut-out area (2.80" H x 7.275"
W /
7.11 cm H x 0.7 cm
W)
indicated b
y
the dotted line
.
TP
T 468 4-
g
an
g
Cut-out
T
emplate