Extron Electronics TP Transmitters User Guide - Manual (Page 19)

Extron TP Transmitters • Installation and Operation Extron TP Transmitters • Installation and Operation
Installation and Operation, cont’d
TP T 468
INPUT
H. SHIFT
AUDIO
NO MONITOR
MONITOR
MONITOR
MIN/MAX
4
13
3
2 1 14
5
12 10
15
Figure 2-16 — Installation features, TP T 468
Transmission of component video, S-video, or composite video
on the computer video input requires that internal jumpers
(TP T 15HD A and TP T 15HD AV) or a DIP switch (TP T 468) be
reconfigured. See “Video jumpers,” or “Video DIP switch,”
earlier in this chapter.
1 Computer Input connector — Connect a
computer video source to this 15-pin HD
female connector.
Input only sync signals, no video
signals, on the sync pins (pins 13 and 14).
For component video, use the R (R-Y) and R return pins
(pins 1 and 6), G (Y) and G return pins (pins 2 and 7),
and B (B-Y) and B return pins (pins 3 and 8).
For S-video, use the R, R return (C-chroma), G, and G
return (Y-luma) pins.
For composite video, use the G pin and the associated
return pin. For additional genlocked video signals, use
the R, B, and associated return pins.
2 Audio input connector — Connect PC audio to this 3.5 mm,
stereo jack. Wire the male plug as shown in figure 2-17.
Input only analog, line level, audio signals on the audio
input connector.
Sleeve ( )
Ring (R)
Tip (L)
Figure 2-17 — Audio input wiring
3 Buffered Local Monitor output connector — Connect a local
monitor video cable to this 15-pin HD female connector.
4 ID bit switches (TP T 15HD A and TP T 15HD AV) — If a local
monitor is installed, set both switches to off. If no local monitor
is installed, set both switches to on.
5 DDSP switch — This switch turns on Digital Display Sync
Processing, disabling sync processing for LCD projectors and
other displays that cannot tolerate processed sync.
DDSP disables the horizontal shift control.
5 1
15 11
6 10
Female
2-22 2-23