Extron Electronics SCS 300 User Guide - Manual (Page 7)

About this Manual
This manual documents the features, installation, operation,
and specifications of the Extron SCS 300 Sync Converter/
Stabilizer.
About the SCS 300
The SCS 300 Sync Converter/ Stabilizer is a 1U high, quarter
rack width, 6" deep, sync converter and stabilizer with
Advanced Digital Sync Processing (ADSP ™ ). The SCS 300
accepts RGBHV, RGBS, RGsB, or RsGsBs signal inputs;
automatically strips off the sync on green or the sync on red,
green, and blue; and outputs RGBHV/RGBS or RGsB through
five BNC connectors on the rear panel.
An identical and simultaneous output is provided via a
15-pin HD (VGA) connector on the front panel. The output
sync is restored to the original timing using the Extron ADSP
technology. Horizontal shift adjustments are made from the
front panel. A bank of eight DIP switches allows the user to set
various sync output formats, set sync input impedance, and
control the removal of serration pulses.
Features
Inputs — Female BNCs for RGBHV, RGBS, RGsB, or RsGsBs
inputs
Simultaneous output — Female 15-pin HD and female BNCs
for RGBHV, RGBS, RGsB, or RsGsBs outputs.
Signal conversion — With all DIP switches down, any input
signal type (RGBS, RGsB or RsGsBs) is converted to
RGBHV output.
Flexibility — DIP switches allow sync control for various sync
output formats, input impedance termination, and the
passing or removal of serration pulses.
Output sync restoration — Using ADSP, the output sync can be
restored to the original timing.
Furniture and wall mountability — The SCS 300 can be
mounted onto or in furniture or to a projector pole,
using a suitable Extron mounting kit (see Appendix A,
"Reference Material," for a list).
SCS 300 • Introduction
Introduction
1-2