Extron Electronics MTPX Plus 6400 Series Setup Guide - Manual (Page 9)

NOTE: The other MTPX Plus matrix sizes are housed in the same
10U enclosure as the MTPX Plus 6464, but have fewer
connectors to accommodate their smaller matrix sizes.
CAUTION: Turn off power to the input and output devices,
and disconnect their power cords before making
connections.
Inputs
a TP inputs — Connect compatible TP inputs to the
Input RJ-45 connectors.
NOTE: Configure the switcher for the appropriate input
(RS-232 or audio) for each TP input. See “ Defining the
Audio/RS-232 Wire Pair and Configuring the Remote
Port
“ on page 17.
b Local RGB (VGA) inputs 1 through 8 — Connect
analog computer video sources to the Local Inputs
15-pin HD female connectors.
NOTE: The local RGB connectors can also accept
HD component video, component video, S-video, or
composite video.
c Local audio inputs — Connect balanced or unbalanced stereo
audio inputs to the Audio 5-pole captive screw connectors.
LR
Unbalanced Stereo Input Balanced Stereo Input
Ring
Sleeve (s)
Tip
Sleeve
Tip
Sleeve
Tip
Tip
Ring Do not tin the wires!
Figure 3. Audio Input Connector Wiring
d Input Select switches 1 through 8 — Set the Input Select
RJ-45
INPUT
SELECT
LOCAL
1 2 3 4
RJ-45
LOCAL
5 6 7 8
DIP switches for each input that can be either local or on
TP cable from an MTP transmitter.
RJ-45 (down) for an input from an MTP transmitter (
a )
Local (up) for a local (RGB video and audio) input
(
b and c )
RS-232 Output Inserts
e RS-232 Output Insert connectors — For bidirectional RS-232 data
that is routed to a specific (unswitchable) TP output, connect a
serial device to one of the RS-232 Output Insert 3-pole captive
screw connectors.
Receive (Rx)
Transmit (Tx)
Ground ( )
Bidirectional
RS-232
Device
Ground ( )
Receive (Rx)
Transmit (Tx)
Rx Tx
Do not tin
the wires!
Figure 4. RS-232 Output Inserts Connector Wiring
NOTES: • Each RS-232 Output Insert must be enabled. See
the RS-232 output inserts and UARTS ports enables
SIS commands on page 25.
• The switch time for the RS-232 output insert is
50 ms.
Outputs
NOTES: • All matrix sizes have four local output RGB connectors
( g ) (always outputs 1 through 4) and eight local audio
output connectors ( h ) (always outputs 1 through 8).
• The video that is output on the local video connectors
is converted from the tied proprietary TP input signal
or the local (VGA) input.
• The local video output connectors can also output
HD component video, component video, S-video, or
composite video if that is the video format that was
input.
• For NTSC component video, S-video, or composite video
local outputs, set the output to no sync processing. See
the
Local video output sync polarity SIS commands on
page 29.
f TP outputs — Connect compatible MTP receivers
to the Output RJ-45 connectors.
g Local RGB (VGA) outputs — Connect RGBHV video
displays to the female Local Outputs (VGA)
15-pin HD connectors.
8 MTPX Plus 6400 • Installation 9 MTPX Plus 6400 • Installation