Extron Electronics ISM 182 - Manual (Page 36)

Operation, cont’d
Integration Scaling Matrix Switcher • Operation 3-14
User Presets menu
Figure 3-11 is a flowchart that shows an overview of the User Presets menu, the
Save Preset and Erase Preset submenus, and the available settings.
Use either Adjust knob
to select a preset or no
preset (N/A). Press Next. Use either Adjust knob
to select a preset or no
preset (N/A). Press Next.
If necessary,
select the
unselected
output.
1
OUTPUTS
2
Default
Cycle
Menu
Menu
Next 1
OUTPUTS
If necessary,
select the
unselected
output.
2
Next
10 sec.
10 sec.
Video & Audio
Configuration
Menu
Output
Configuration
Menu
Advanced
Configuration
Menu
Memory
Menu
Next
Exit Menu
Press Next to Exit
Menu
Save Out #2 Preset
1 2 3
Erase Out #1 Preset
1 2 3
Next
NOTE To save a preset for the second
output after saving for the
first, start over from the
default cycle.
10 sec.
NOTE To erase a preset for the second
output after erasing for the
first, start over from the
default cycle.
Figure 3-11 — User Presets menu flowchart
Save Preset submenu
Select the output with the settings that you want to save as a preset by pressing the
desired Output button.
Rotate either the Adjust or the Adjust knob while in the Save Preset submenu to
highlight (< >) one of three memory presets for the selected output or highlight
N/A for no preset. Press the Next button to save the current settings to the selected
preset. Select N/A and press the Next button to exit without saving the settings.
Presets, which are saved values of the current color, tint, contrast, brightness, detail,
sizing, and centering settings, are saved in nonvolatile memory; when the ISM is
powered down and later powered back up, the settings are available for selection.
Saving the settings to a preset overwrites the settings previously written to that
preset.
The color, tint, contrast, brightness, detail, sizing, and centering adjustments
are tailored for the selected output rate. If you change the output rate and then
recall a preset for the earlier rate, the adjustments recalled in the preset have no
effect on the video output. However, if you then change back to the earlier
output rate, the effects of the adjustments appear on the screen if they were not
overwritten for the old output rate.