Extron Electronics IPL T S Series User Guide - Manual (Page 48)

Communication and Control, cont’d
IPL T S Series • Communication and Control 4-8
Command
ASCII (T
elnet)
(host to unit)
URL Encoded (W
eb)
(host to unit)
Response (unit to host)
Additional description
V
iew pass-thr
u
mode
24
E
X!
CD
}
W
X!
CD
|
X5)
,
X5#
,
X2!]
Ether
net data port
Set curr
ent connection
port timeout
E
0*
X6(
TC
}
W0%2A
X6(
TC
|
Pti0*
X6(]
The curr
ent port timeout period applies
to the curr
ently open T
elnet session only
.
When you start another T
elnet session, it
uses the default global port timeout period. X6(
= timeout period in seconds. See
the description above. This variable is applicable only when the IPL
T S unit is
connected via Ethernet. If the IPL
T S device
is connected via RS-232 pr
otocol, only the
global timeout commands apply
, and any
commands involving
X6(
r
eturn the E13
err
or r
esponse.
V
iew curr
ent
connection port timeout
E
0TC
}
W0TC
|
X6(]
Set global IP
port
timeout
E
1*
X6(
TC
}
W1%2A
X6(
TC
|
Pti1*
X6(]
The global port timeout is the default timeout period for all T
elnet sessions.
X6(
= IP
connection timeout period
in seconds. Each step is specified in 10-second intervals (1 - 65000, default = 30 = 300 seconds). If no data is received during the specified period, the Ethernet connection closes. Responses ar
e
returned with leading zer
os.
This timeout period is applicable only when the IPL
T S unit is connected via
Ethernet, and you must be logged in as an administrator to change this setting.
V
iew global IP
port
timeout
E
1TC
}
W1TC
|
X6(]