Extron Electronics IN31608 - Manual (Page 11)

8
IN31608 OPERATION MANUAL - REV 1.6 1/4/01

2001 - INLINE, Inc.
Power On Settings
The IN31608 utilizes Power On settings to access certain parameters of the unit. To access a Power On
adjustment, you must depress a specific button while turning the unit’s power switch to ON. If power is already
on, the user can hold down the indicated button and switch the power off and then back on.
IN31608 POWER ON OPTIONS
F1 Factory Default Setting
BLANK Blank Factory Default Setting
MUTE Toggle Front Panel Enable
MODE Front Panel Test Mode
SAVE Toggle Mode (Matrix / Direct)
OUT1 Direct Mode Setup
OUT2 Load Projector Code Memories with Test Strings
OUT3 Clears the Projector Port Memories
OUT4 Enable Genlock operation / vertical interval switching
INPUT1 Set RGB Delay to 0.0 seconds
INPUT2 Set RGB Delay to 0.5 seconds
INPUT3 Set RGB Delay to 1.0 seconds
INPUT4 Set RGB Delay to 1.5 seconds
INPUT5 Set RGB Delay to 2.0 seconds
INPUT6 Set RGB Delay to 2.5 seconds
INPUT7 Set RGB Delay to 3.0 seconds
INPUT8 Set RGB Delay to 3.5 seconds
INPUT9 Set RGB Delay to 4.0 seconds
INPUT10 Set RGB Delay to 4.5 seconds
INPUT11 Set RGB Delay to 5.0 seconds
INPUT12 Set RGB Delay to 5.5 seconds
INPUT13 Set RGB Delay to 6.0 seconds
RESET TO FACTORY DEFAULT (F1), (BLANK)
To reset the unit to the factory default setting, hold down the F1 or BLANK button while turning on the unit.
The factory default settings are as follows:
Parameter Default State
Front Panel Operation Enabled
RGB Delay 0.0 secs.
Audio Levels
Normalized to Default, -3 dB.
Input = 128, Output = 52
Serial Control Port 9600 baud, 8 data, no parity
Command Code: [ ]
Projector Control Port RS-232, 9600 baud, 8 data, no parity
Group 1 All Boards
Group 2 No Boards
Group 3 No Boards
Code Delay 0 msecs.
Vertical Interval Switching /
Genlock Operation
Disabled