Extron Electronics FOXBOX Tx_Rx DVI Plus User Guide - Manual (Page 44)

Maximum receiver sensitivity
Singlemode ...................... -18 dBm, typical
Multimode ....................... -12 dBm, typical
Optical loss budget
Singlemode ...................... 13 dB, maximum
Multimode ....................... 7 dB, maximum
Video — FOXBOX Tx/Rx VGA and FOXBOX Tx VGA/YUV
Signal type
VGA models ..................... VGA-UXGA RGBHV, RGBS, RGsB, RsGsBs
VGA/YUV models ............. VGA-UXGA RGBHV, RGBS, component video
Gain ............................................ Unity
Pixel data bit depth ..................... 8 bits per channel, 3 channels (R, G, B; or YUV)
Maximum resolution ................... 1600x1200 or 1080p @ 60 Hz, digitized pixel for pixel; higher resolutions up to 2048x1120,
undersampled
Video input — FOXBOX Tx VGA and FOXBOX Tx VGA/YUV
Number/signal type
VGA models ..................... 1 VGA-UXGA RGBHV, RGBS, RGsB, RsGsBs
VGA/YUV models ............. 1 VGA-UXGA RGBHV, RGBS, component video (bi- or tri-level YUV, 480p, 576p, 720p, 1080i,
1080p)
Connectors ................................. 1 female 15-pin HD
Nominal level .............................. 1 Vp-p for Y of component video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
Minimum/maximum levels ........... Analog: 0.3 V to 0.75 Vp-p with no offset, terminated
Impedance .................................. 75 ohms
Horizontal frequency ................... 24 kHz to 100 kHz
Vertical frequency ........................ 40 Hz to 120 Hz
Return loss .................................. <-40 dB @ 5 MHz
Video output — FOXBOX Rx VGA
Number/signal type ..................... With input from a FOXBOX Tx VGA or a FOX 500 Tx:
1 VGA-UXGA RGBHV, RGsB (follows input or can be set by user)
With input from a FOXBOX Tx VGA/YUV:
1 VGA-UXGA RGBHV, RGBS, component video (bi- or tri-level YUV, 480p, 576p, 720p, 1080i,
1080p)
Connectors ................................. 1 female 15-pin HD
Nominal level .............................. 1 Vp-p for Y of component video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
Minimum/maximum levels ........... 0.3 V to 0.75 Vp-p, terminated
Impedance .................................. 75 ohms
Return loss .................................. -30 dB @ 5 MHz
DC offset .................................... ±5 mV with input at 0 offset
Video delay ................................. 1-2 frames
Sync — FOXBOX Tx/Rx VGA and FOXBOX Tx VGA/YUV
Input type
VGA model ...................... RGBHV, RGBS, RGsB, RsGsBs
VGA/YUV model ............... RGBHV, RGBS, component video (bi- or tri-level sync)
Output type
VGA model ...................... RGBHV, RGsB (follows input or can be set by user)
VGA/YUV model ............... Output via a FOXBOX Rx VGA or a FOX 500 Rx: RGBHV, component video (bi- or tri-level)
Input level ................................... 2.5 V to 5.0 Vp-p
Output level ................................ TTL: 5.0 Vp-p, unterminated, on HV, for RGBHV, RGBS
0.3 Vp-p for component video (bi-level sync, unterminated) or for Gs (SOG), terminated
0.6 Vp-p for component video (tri-level sync)
Input impedance ......................... 10k ohms
FOXBOX Tx/Rx • Reference Information 38