Extron Electronics FOXBOX Tx_Rx DVI Plus User Guide - Manual (Page 27)

Unit-initiated Messages
When a local event, such as an equipment power-up, occurs, the unit responds by sending a
message to the host. The unit-initiated messages are listed below:
(c) Copyright 2010, Extron Electronics FOXBOX Tx VGA, Vx.xx, 60-934-xx]]
- or -
(c) Copyright 2010, Extron Electronics FOXBOX Rx VGA, Vx.xx, 60-934-xx]]
- or -
(c) Copyright 2010, Extron Electronics FOXBOX Tx VGA/YUV, Vx.xx, 60-1058-xx]]
- or -
(c) Copyright 2010, Extron Electronics FOXBOX Tx DVI, Vx.xx, 60-935-xx]]
- or -
(c) Copyright 2010, Extron Electronics FOXBOX Rx DVI, Vx.xx, 60-935-xx]]
- or -
(c) Copyright 2010, Extron Electronics FOXBOX Tx DVI Plus, Vx.xx, 60-1060-xx]]
- or -
(c) Copyright 2010, Extron Electronics FOXBOX Rx DVI Plus, Vx.xx, 60-1060-xx]]
The connected unit issues the appropriate copyright message (above) when it first powers
on. Vx.xx is the firmware version number; 60-xxxx-xx is the part number of the connected
unit.
Reconfig]
The unit sends the Reconfig message whenever the video input signal to the transmitter is
changed.
1Lnk
X2) •2Lnk X2) •RGB X2) •Aud X2) ]
The unit sends the status message whenever a change in the fiber link and video and audio
connection occurs.
Dip
X$X$ ]
The unit sends the DIP switch position message whenever a change in the DIP switch
settings occurs on the receiver.
FOXBOX Tx/Rx • Remote Control 21