Connections and configuration, Transmitter connections and indicators, Eceivers (see – Extron Electronics FOXBOX Tx_Rx DVI Plus User Guide User Manual
Page 14: Connections and, Configuration
Connections and Configuration
Transmitter Connections and Indicators
FOXBOX Tx VGA Rear Panel
FOXBOX Tx DVI Plus Rear Panel
Front Panel
Front Panel
FOXBOX Tx VGA
RGB
OVER
TEMP
AUDIO
CONFIG
OPTICAL
Rx
Tx
LINK
LINK
AUDIO
RGB INPUT
FOXBOX Tx VGA
RS-232
OVER FIBER ALARM
Tx Rx
1 2
12V
1.0A MAX
POWER
DVI
OVER
TEMP
AUDIO
CONFIG
OPTICAL
Rx
Tx
LINK
LINK
AUDIO
DVI-D INPUT
RS-232
OVER FIBER ALARM
Tx Rx
1 2
FOXBOX Tx DVI Plus
FOXBOX Tx DVI Plus
12V
1.0A MAX
POWER
9
9
9
8
8
3
3
7
7
5
5
4
4
1
2
9
9
9
6
6
Figure 2.
FOXBOX Tx Transmitter Connectors
NOTES: • The FOXBOX Tx VGA/YUV looks similar to the FOXBOX Tx VGA, with the
exception of the name on the unit and the label on the input connector.
• The FOXBOX Tx DVI (non-Plus) looks similar to the FOXBOX Tx DVI Plus, with
the exception of the name on the unit.
a
RGB and RGB/YUV Input connectors
FOXBOX Tx VGA — Connect an analog VGA-UXGA RGB video source to this 15-pin
HD female connector.
FOXBOX Tx VGA/YUV — Connect bi-level or tri-level sync YUV video or an analog
VGA-UXGA RGB video source to this 15-pin HD female connector.
b
DVI-I Input connector (FOXBOX DVI only) — Connect a single link of DVI-D to this
DVI-I connector (see “
“ on page 14 for pin assignments).
NOTE: The FOXBOX DVI accepts only the digital signals on the DVI-I Input
connector. The analog pins on the port are not connected.
c
Audio connector — Plug an audio input into the transmitter via this stereo mini jack
connector.
NOTE: See figure 3 to identify the tip, ring, and sleeve when you are making
connections for the transmitter from existing audio cables. A mono audio
connector consists of the tip and sleeve. A stereo audio connector consists
of the tip, ring, and sleeve.
Tip (+)
Sleeve ( )
Sleeve ( )
Ring (-)
Tip (+)
RCA Connector
3.5 mm Stereo Plug Connector
(balanced)
Figure 3.
Typical Audio Connectors
The input audio level can be set via RS-232 control (see “
FOXBOX Tx/Rx • Installation and Operation
8