Extron Electronics FOXBOX Tx_Rx DVI Plus User Guide - Manual (Page 16)

g
Configuration port — Connect a controlling device, such as a PC, to this port via a
2.5 mm mini jack TRS RS-232 cable for RS-232 protocol control of all FOXBOX functions.
See “
Front panel Configuration ports “ on page 16 for more details on the adapter
cable and “ Remote Control “ on page 19 for SIS commands and software control.
The TRS RS-232 cable is included with the Tx models.
h
DC power connector — Plug the included external 12 VDC power supply into this
connector (see “ Power supply wiring “ on page 17, to wire the connector.
i
Indicators —
Power LED — This LED lights to indicate that power is applied to the unit .
Over Temp LED — This LED lights to indicate that the unit is operating at a dangerously
high temperature (approximately 167 °F [75 °C]) and that equipment damage is
imminent.
RGB (FOXBOX VGA), RGB/YUV (FOXBOX VGA/YUV), or
DVI (FOXBOX DVI) LED — This LED lights when the transmitter detects a signal on its
video input, as follows:
RGB LED — Horizontal sync (H) (for RGBHV video) or Green (Sync on green) (G) (for
RGsB or RsGsBs video)
RGB/YUV LED — Horizontal sync (H) (for RGBHV video) or luminance (Y) (for
component video)
DVI LED — DVI video input
Audio LED — This LED lights when the transmitter detects a low level audio signal for a
short period of time. It goes dark if the audio signal drops below the minimum threshold
for a short period of time.
FOXBOX Tx/Rx • Installation and Operation 10