Extron Electronics FOX RS 104 User Guide User Manual
Page 29
FOX RS 104 RS-232 Inserter • Remote Control
23
The fields on the Passwords page are for entering and verifying administrator and user
passwords. Passwords are case sensitive and are limited to up to 12 uppercase and
lowercase alphanumeric characters. Each password must be entered twice;
once in the
Password
field and then again in the
Re-enter
Password
field.
Characters in these fields are masked by asterisks (*****). If you do not want to password
protect an access level, leave the
Password
field and the
Re-Enter
Password
field blank.
After entering the password in both fields, click the
Submit
button.
NOTE: An administrator password must be created before a user password can be
created.
Resetting a password
Reset an existing password so that no password is required as follows:
1.
Clear any existing password.
2.
Enter a single space character in the
Password
and
Re-enter
Password
fields.
3.
Click the
Submit
button.
Firmware Upgrade page
The Firmware Upgrade page (see figure 15) provides another way to replace the firmware
that is coded on the control board of the inserter without taking the inserter out of service.
Access the page by clicking the
Firmware
Upgrade
link on the System Settings page.
System Settings
Port Settings
Passwords
Refresh
Figure 15.
Firmware Upgrade Page
NOTE: The Firmware Upgrade page is only for replacing the firmware that controls all
inserter operation. To insert your own custom HTML pages, see “