Rear panel reset operations, Performing soft system resets (resets 3, 4, and 5), Resets 3, 4, and 5) – Extron Electronics FOX RS 104 User Guide User Manual
Page 15
FOX RS 104 RS-232 Inserter • Installation and Operation
9
Rear Panel Reset Operations
The rear panel Reset button initiates four levels of resets (numbered 1, 3, 4, and 5 for the
sake of comparison with an Extron IPL product). The Reset button is recessed, so use a
pointed stylus, ballpoint pen, or small screwdriver to access it.
See the
on the next page for a summary of the modes.
ATTENTION: Review the reset modes carefully. Using the wrong reset mode may result
in unintended loss of flash memory programming, port reassignment, or a controller
reboot.
Performing Soft System Resets (Resets 3, 4, and 5)
Perform a soft reset of the inserter as follows (see figure 8):
1.
Use a small screwdriver to press and
hold the rear panel Reset button until the
rear panel Reset LED blinks once (events reset), twice (system reset), or three times
(absolute reset).
Release, then immediately
press and release again.
RESET
RESET
RESET
Release, then immediately
press and release again.
6 seconds
9 seconds
Press and hold
the Reset button.
3 seconds
Reset LED flashes once.
Release, then immediately
press and release again.
Reset LED flashes twice.
Press and hold
the Reset button.
Press and hold
the Reset button.
Reset LED flashes
three times.
IP Settings
Reset
(Mode 4)
Absolute
Reset
(Mode 5)
Events
Reset
(Mode 3)
Figure 8.
Resets
2.
Release the Reset button and then immediately press and release the Reset button
again. Nothing happens if the second momentary press does not occur within 1
second.