Extron Electronics FOX RS 104 User Guide - Manual (Page 20)

FOX RS 104 RS-232 Inserter • Remote Control 14
X1#
= Number of open connections 0 – 200
X1$
= Password 12 alphanumeric characters
NOTE: The HTML language reserves certain characters for specific functions (see “ Special Characters ” on page 28).
X1%
= DHCP 0 =off, 1 = on
X1^
= Baud rate 9600, 19200, 38400, 115200
X1&
= Parity odd, even, none, mark, space (Only the first letter required.)
X1*
= Data bits 7, 8
X1(
= Stop bits 1, 2
X2)
= Port type (always 0 = RS-232)
X2!
= Verbose mode 0 = clear/none (default for Telnet connection) 2 = tagged responses for queries
1 = verbose mode (default for RS-232)
3 = verbose mode and tagged for queries
NOTE: If tagged responses is enabled, all read commands return the constant string and the value as the set command does
(for example, the read matrix name command, E CN } , returns Ipn• X%] ).
X2@
= Port timeout interval (in 10-sec. increments) 1 (= 10 seconds) – 65000 (default is 30 = 300 seconds = 5 minutes)
X2#
= Direct access port map 0 (= disabled) or 1024 and up (default is 2001 )