Extron Electronics FOX RS 104 User Guide User Manual

Page 26

FOX RS 104 RS-232 Inserter • Remote Control

IP Address field — The

Address

field contains the IP address of the connected

inserter. This value is encoded in the flash memory of the inserter.
Valid IP addresses consist of four 1-, 2-, or 3-digit numeric octets separated by dots
(periods). Each field can be numbered from 000 through 255. Leading zeroes, up to 3 digits
total per field, are optional. Values of 256 and above are invalid.
The factory-installed default address is 192.168.254.254, but if this conflicts with other
equipment at your installation, you should ask your network administrator for a new, valid
address.

NOTE: IP address changes can cause conflicts with other equipment. Only local system

administrators should change IP addresses.

Gateway IP Address field — The

Gateway

Address

field identifies the address of the

gateway to the mail server to be used if the inserter and the mail server are not on the same
subnet.
The gateway IP address has the same validity rules as the system IP address.
Subnet Mask field — The

Subnet

Mask

field is used to determine whether the inserter is

on the same subnet as the mail server when you are subnetting.
MAC Address field — The Media Access Control (

MAC

)

Address

is hardcoded in the

inserter and cannot be changed.
Firmware field — The

Firmware

field identifies the installed firmware version. This field is

hardcoded in the inserter and cannot be changed.
Model field — The

Model

field identifies the number of inputs and outputs. This field is

hardcoded in the inserter and cannot be changed.
Part Number field — The

Part

Number

field identifies the part number of your inserter.

This field is hardcoded in the inserter and cannot be changed.
Date/Time Settings fields — The

Date/Time

Settings

fields (see figure 12) provide a

location for viewing and setting the time functions.

Figure 12.

Date/Time Settings Fields