Extron Electronics DVI DA Plus Series User Guide User Manual

Page 11

CAUTION: These products are intended to be supplied by a Listed Power

Unit marked “Class 2” or “LPS”, rated 12 VDC, maximum 1.0 A
(DVI DA4 Plus) or maximum 3.0 A (DVI DA6 Plus and DVI DA8 Plus).
Always use a power supply supplied by or specified by Extron. Use of an
unauthorized power supply voids all regulatory compliance certification
and may cause damage to the supply and the end product.

Unless otherwise stated, the AC/DC adapters are not suitable for use in
air handling spaces or in wall cavities. The power supply is to be located
within the same vicinity as the Extron A/V processing equipment in an
ordinary location, Pollution Degree 2, secured to the equipment rack
within the dedicated closet, podium or desk.

The installation must always be in accordance with the applicable
provisions of National Electrical Code ANSI/NFPA 70, article 75 and the
Canadian Electrical Code part 1, section 16. The power supply shall not
be permanently fixed to building structure or similar structure.

NOTE:

•

The length of the exposed wires in the stripping process is critical. The

ideal length is 3/16 inches (5 mm). Any longer and the exposed wires may
touch, causing a short circuit between them. Any shorter and the wires
can be easily pulled out even if tightly fastened by the captive screws.

•

Do not tin the wires. Tinned wire does not hold its shape and can become

loose over time.

Input connector — Connect a single link DVI-D source device, with a resolution range

up to 1920x1200 or 1080p@60 Hz, to the female DVI-I input, using a DVI cable.

NOTE: Although these distribution amplifiers have DVI-I connectors, they are only

compatible with single link DVI-D video signals.

Input EQ conditions input signals to ensure the integrity of the signals delivered to the
output devices.

Output Connectors — Use DVI-I cables to connect up to four (DVI DA4 Plus),

six (DVI DA6 Plus) or eight (DVI DA8 Plus) display devices.

NOTE: The actual signal transmission distance can vary and depends on signal

resolution, cable quality, graphics card, and display used in the system.

DVI DA Plus Series • Installation