Xylem LMN - Manual (Page 4)

EC Declaration of Conformity (valid only for Xylem Service Austria GmbH aggregate supplied in its entirety,
according to EC Directive on Machinery 2006/42/EC, Annex II A)
The manufacturer,
Xylem Service Austria GmbH
Ernst Vogel-Strasse 2
2000 Stockerau
Austria
of the pump unit (from the standard product line) hereby declares:
LM 65-315, LM 80-315, LM 100-160, LM 100-200, LM 100-250, LM 100-315, LM 125-250, LM
125-200, LM 125-315, LM 150-250, LM 150-315
LMN 32-125, LMN 32-160, LMN 32-200, LMN 40-125, LMN 40-160, LMN 40-200, LMN 40-250,
LMN 50-125, LMN 50-160, LMN 50-200, LMN 50-250, LMN 65-125, LMN 65-160, LMN 65-200,
LMN 80-160, LMN 65-160, LMN 65-250, LMN 80-200, LMN 80-250, LMN 80-250
that the above mentioned pump unit complies with all regulations of these guidelines in their current
version:
EC-Directive 2006/42/EC ”Machinery”
EC-Directive 2009/125/EC ”Ecodesign” and
Commission Regulation (EC) No. 547/2012
EC-Directive 2004/108/EC ”EMC”
The technical documentation created by Directive 2006/42/EC, Annex VII A.
The aforementioned technical documentation get submitted upon request to the competent authority in
electronic form on data storage medium.
Responsible for compiling the technical documentation:
Dipl. Ing. Gerhard Fasching
Abtlg. Research & Development
Xylem Service Austria GmbH
Ernst Vogel-Strasse 2
2000 Stockerau
Austria
Among others, the following harmonised standards have been applied:
EN 809 :1998+A1:2009+AC:2010(D)
EN 953 :1997+A1:2009(D)
EN ISO 12100 :2010(D)
EN 60204-1 :2006/A1:2009 D
A change to an aggregate which was not approved by us invalidates this declaration. This also applies in
the case that the aggregate is installed in equipment that does not have the declaration of conformity in
accordance with the Directive on Machinery, 2006/42/EC.
Stockerau, 05.07.2013
................................................................................................
Dipl.Ing. Gerhard Fasching
Manager Research & Development