Xylem IM043 AQUAVAR Variable Speed Pump Control - Manual (Page 25)

24
6. Press to advance the display to:
This display shows the last recorded error or
fault encountered by the AQUAVAR controller.
7. Press to advance the display to: This in
the error which occurred before the last one.
8. Press to advance the display to:
The error before error 2.
9. Press to advance the display to:
The error before error 3.
10. Press to advance the display to:
The error before error 4.
11. Press to advance the display to:
This is the total amount of run time of the
motor. It can be reset using a method
described later.
12. Saving changes
Press to advance the display to:
13. Press and hold down BOTH arrows
at the same time until the display changes to:
This will allow you to save the changes you
have made in the microprocessor memory.
14. After about five seconds the display will
automatically return to:
Push . The AQUAVAR controller will begin to automatically maintain system pressure at the
point you have selected and the display will show the pressure set point.
Programming
ERROR 1
ERROR 2
ERROR 3
ERROR 4
*
*
*
*
t
t
t
SAVE ??? +
SAVE ??? SAVED
iNVERTER STOP - ON->START
If the AQUAVAR controller is not maintaining the rating you selected, check the sen-
sor adjustment procedures on page 56 and check your rotation.
Note
t
t
ERROR 5
TOTAL RUN TiME
0000:00
*
*
*