Xylem IM250R03 Aquavar CPC-FD - Manual (Page 41)

41
✔
TECHNICAL DATA
CE Marking
A CE mark is attached to the drive to verify that the drive follows the provisions of the European Low
Voltage and EMC Directives.
Note: The 600 V ACS550-U1 drives are not CE approved.
Compliance with the EMC Directive
The Directive defines the requirements for immunity and emissions of electrical equipment used
within the European Union. The EMC product standard (IEC/EN 61800-3 [2004]) covers requirements
stated for drives.
Compliance with IEC/EN 61800-3 (2004)
C-Tick Marking
The drive carries C-Tick marking.
C-Tick marking is required in Australia and New Zealand. A C-Tick mark is attached to the drive to
verify compliance with the relevant standard (IEC 61800-3 (2004) — Adjustable speed electrical power
drive systems — Part 3: EMC product standard including specific test methods), mandated by the Trans-
Tasman Electromagnetic Compatibility Scheme.
The Trans-Tasman Electromagnetic Compatibility Scheme (EMCS) was introduced by the Australian
Communication Authority (ACA) and the Radio Spectrum Management Group (RSM) of the New
Zealand Ministry of Economic Development (NZMED) in November 2001. The aim of the scheme is
to protect the radio frequency spectrum by introducing technical limits for emission from electrical/
electronic products.
Compliance with IEC/EN 61800-3 (2004)