Armasight NSCCOLR00139DA1 CO-LR GEN 3 Alpha MG Night Vision Long Range Clip-On System - Manual (Page 28)

28
3.3.3 OPERATING IN CHANGING LIGHT CONDITIONS
If a mission must be carried out in changing light conditions, you can deactivate the bright light protec-
tion system of the CO-LR. To shut down the protection system, close the photoreceiver by flipping up
the pivoted shutter.
CAUTION:
After your mission is complete, open the photoreceiver by flipping the pivoted shutter down.
3.3.4 SHUT-DOWN
Shut-down the CO-LR as follows:
1. Turn the device OFF. The green glow will disappear.
2. Place the cap over the objective lens.
3. Remove the CO-LR from the weapon.
4. Remove the light suppressor from the output lens.
5. Replace the cap on the output lens.
6. Remove the IR850 from the CO-LR Weaver rail.
7. Remove the battery.
CAUTION:
Do not store the equipment with the battery still in it.
CAUTION:
Remove the light suppressor from the CO-LR to avoid deformation or damage.
8. Ensure that the CO-LR and any accessories are clean and dry before placing them into the storage
case.
9. Place the CO-LR and any accessories into the storage case.
10. Store the CO-LR and accessories in the appropriate locations in the case and close the cover.