Installation – Asus WL-330 User Manual
Page 23
23
ASUS Pocket Wireless Access Point
2. Installation
If the cells of multiple ASUS Pocket APs overlap, then the wireless mobile
client may switch from one ASUS Pocket Wireless APto another. During the
transfer from one ASUS AP to another, the wireless mobile client maintains an
uninterrupted connection to the network. This is called “roaming.”
Multiple ASUS Pocket APs connected to a common Ethernet network form an
Extended Service Set (ESS). All members of an Extended Service Set are
configured with an ID, known as the SSID or ESSID. Wireless mobile clients
must be configured with the same SSID as the ASUS Pocket APs on the
network since it can only roam between ASUS Pocket APs sharing the same
SSID.
Important notes on roaming
•
An ASUS WLAN card can only roam between APs of the same type.
•
All ASUS Pocket Wireless APs must have the same SSID.
•
All computers with ASUS WLAN cards must have the same SSID as the Access
Points to enable roaming.
•
If WEP encryption is enabled, all ASUS APs and client adapters must use the
same encryption level and WEP key(s) to establish connection.
•
ASUS Pocket Wireless AP’s cells must overlap to provide an uninterrupted
connection for a roaming client.
•
ASUS Pocket Wireless APs that use the same channel should be installed
away from each other to reduce potential interference.
•
We strongly recommended that you perform a site survey using the ASUS
Pocket Wireless AP utility to determine the best location for each device.