Asus WL-330 - Manual (Page 13)

13 ASUS Pocket Wireless Access Point
1. introduction
1.4.4 LED indicators
The ASUS Pocket Wireless AP comes
with a Power, Wireless, and Ethernet LED
indicators. Refer to the table below for
LED indications.
1.4.3 Rear view
DC-IN
socket
Ethernet
port Reset
button
Ethernet port. This port connects the
supplied RJ-45 plug and cable.
DC IN socket. This socket connects the
power adapter plug.
Reset button. Press this button for more
than five seconds (in AP or Ethernet mode)
to load the default values. In Ethernet
adapter mode, press this button for less
than five seconds to connect to the first
saved wireless connection in the profile
table.
(AP = Access point, EA = Ethernet adapter)
LED Status Mode* Indication
Power ON AP/EA The device in ON and ready.
OFF AP/EA The device is OFF or performing boot sequence
Blinking AP/EA Firmware upgrade failed.
Wireless ON AP The device is ON and ready.
EA The device is associated with an AP or other wireless device.
OFF AP The device is OFF.
EA The device is not associated with an AP or wireless device.
Blinking AP/EA The device is transmitting or receiving data.
Ethernet ON AP/EA The device is connected to an Ethernet network.
OFF AP/EA The device is OFF or not connected to a network.