Asus Terminator K7 - Manual (Page 94)

94 Chapter 5: BIOS Information
Onboard Parallel Port [378H/IRQ7]
This field sets the address of the onboard parallel port connector. If you disable
this feature, Parallel Port Mode and ECP DMA Select configurations will not
be available. Configuration options: [Disabled] [378H/IRQ7] [278H/IRQ5]
Parallel Port Mode [ECP+EPP]
This field allows you to set the operation mode of the parallel port. [Normal]
allows normal-speed operation but in one direction only; [EPP] allows
bidirectional parallel port operation; [ECP] allows the parallel port to operate in
bidirectional DMA mode; [ECP+EPP] allows normal speed operation in a two-
way mode. Configuration options: [Normal] [ECP] [EPP] [ECP+EPP]
ECP DMA Select [3]
This field allows you to configure the parallel port DMA channel for the selected
ECP mode. This selection is available only if you select [ECP] or [ECP+EPP] in
Parallel Port Mode above. Configuration options: [1] [3]
Onboard Peripheral Resource Control
Onboard AC97 Audio Controller [Auto]
[Auto] allows the motherboard’s BIOS to detect whether you are using
any network/audio device. If a network/audio device is detected, the
onboard network/audio controller will be enabled; if no network/audio
device is detected, the onboard network/audio controller will be
disabled. If you have conflicts with the onboard network/audio
controller, you may set the appropriate field to [Disabled].
Configuration options: [Enabled] [Disabled]