Asus Terminator K7 - Manual (Page 93)

ASUS Terminator K7 Barebone System 93
5.5.2 I/O Device Configuration
Onboard FDC Swap A & B [No Swap]
This field allows you to reverse the hardware drive letter assignments
of your floppy disk drives. Configuration options: [No Swap] [Swap
AB]
Onboard Serial Port 1 [3F8H/IRQ4]
Onboard Serial Port 2 [2F8H/IRQ3]
These fields allow you to set the addresses for the onboard serial
connectors. Serial Port 1 and Serial Port 2 must have different
addresses. Configuration options: [3F8H/IRQ4] [2F8H/IRQ3] [3E8H/
IRQ4] [2E8H/IRQ10] [Disabled]
UART2 Use Infrared [Disabled]
When enabled, this field activates the onboard standard infrared feature and
sets the second serial UART to support the infrared module connector on the
motherboard. If your system already has a second serial port connected to the
onboard COM2 connector, it will no longer work if you enable the infrared feature.
See Standard and Consumer Infrared Module Connector in 3.9.1 External
Connectors. Configuration options: [Disabled] [Enabled]