Asus Terminator K7 - Manual (Page 58)

58 Chapter 3: Motherboard Information
8. Floppy Disk Drive Connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable.
After connecting the single end to the board, connect the two
plugs on the other end to the floppy drives. (Pin 5 is removed to
prevent inserting in the wrong orientation when using ribbon
cables with pin 5 plugged).
A7VC
®
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
A7VC Floppy Disk Drive
Connector
FLOPPY
PIN 1
9. Wake-On-LAN Connector (3-pin WOL_CON)
This connector connects to a LAN card with a Wake-On-LAN
output, such as the ASUS PCI-L101 Ethernet card (see 7.
Appendix). The connector powers up the system when a wakeup
packet or signal is received through the LAN card.
IMPORTANT: To use this feature, enable the Wake-On-LAN
feature in BIOS (see 5.5.1 Power Up Control) and make sure
that system has an ATX power supply with at least 720mA +5V
standby power.
A7VC
®
A7VC Wake-On-LAN Connector
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power
WOLCON
+5 Volt Standby PME
Ground