Asus Terminator K7 User Manual
Page 92
92
Chapter 5: BIOS Information
SDRAM RAS to CAS Delay
This controls the latency between the SDRAM active command and
the read/write command. NOTE: This field will only be adjustable
when SDRAM Configuration is set to [User Define].
PCI Master Read Caching [Disabled]
Default: [Disabled]
Leave on default setting. Configuration options: [Disabled] [Enabled]
Delayed Transaction [Disabled]
Default: [Disabled]
Leave on default setting. Enabled, this frees the PCI Bus when the
CPU is accessing 8-bit ISA devices that normally consume about 50-
60 PCI Clocks without PCI delayed transaction. Select [Disabled] for
ISA devices that are not PCI 2.1 compliant. Configuration options:
[Disabled] [Enabled]
PCI to DRAM Prefetch [Enabled]
Configuration options: [Disabled] [Enabled]
Byte Merge [Disabled]
To optimize the data transfer on PCI, this merges a sequence of
individual memory writes (bytes or words) into a single 32-bit block of
data. However, byte merging may only be done when the bytes within
a data phase are in a prefetchable address range. Configuration
options: [Disabled] [Enabled]
DRAM Read Latch Delay [Auto]
Configuration options: [-0.01 ns] [0.75 ns]...[Auto]
Memory Early/Delay Write [Auto]
Configuration options: [0.0 ns] [0.5 ns]...[Auto]
DIMM Interleave Setting [Auto]
Configuration options: [Auto] [Disabled]
VGA Shared Memory Size
This size cannot exceed the last memory bank size in the system. If
there is only one DRAM bank in the system, this size is set to half of
this DRAM bank size automatically.
Select Display Device