Asus Terminator K7 - Manual (Page 61)

ASUS Terminator K7 Barebone System 61
The following 20-pin PANEL illustration is for items 14-19.
14. System Power LED Connector (3-1 pin PWR.LED)
This 3-1 pin connector connects to the system power LED. The
LED lights up when you turn on the system power, and blinks
when the system is in sleep or soft-off mode.
15. System Warning Speaker Connector (4-pin SPEAKER)
This 4-pin connector connects to the case-mounted speaker.
16. System Message LED Connector (2-pin MSG.LED)
This 2-pin connector is for the system message LED that indicates
receipt of messages from a fax/modem. The normal status for
this LED is ON, when there is no incoming data signal. The LED
blinks when there is data received. The system message LED
feature requires an ACPI OS and driver support.
17. System Management Interrupt Connector (2-pin SMI)
This 2-pin connector allows you to manually place the system
into a suspend mode, or “Green” mode, where system activity is
instantly decreased to save power and to expand the life of certain
system components. Attach the case-mounted suspend switch
this 2-pin connector.
18. ATX Power Switch / Soft-Off Switch Connector (2-pin
PWR.SW)
The system power is controlled by a momentary switch attached
to this connector. Pressing the button switches the system
between ON and SLEEP, or ON and SOFT OFF, depending on
the BIOS or OS settings. Pressing the button while in the ON
mode for more than 4 seconds turns the system off.
19. Reset Switch Connector (2-pin RESET)
This 2-pin connector connects to the case-mounted reset switch
for rebooting the system without turning off the power switch.
A7VC
®
A7VC System Panel Connectors
* Requires an ATX power supply.
PLED
Ground TB_LED PWR
+5 V +5V
Speaker
Ground +5 V ExtSMI# Ground Reset
Ground Ground
Reset SW
Keylock Ground
Power LED
Keyboard Lock Speaker
Connector
ATX Power
Switch*
SMI Lead
Message LED