Asus P5Q SE2 - Manual (Page 56)

2-18 Chapter 2: BIOS setup
Execute-Disable.Bit.Capability.[Enabled]
Allows you to enable or disable the No-Execution Page Protection Technology. Setting this
item to [Disabled] forces the XD feature flag to always return to zero (0).
Configuration options: [Disabled] [Enabled]
The following item appears only when you installed an Intel ® Pentium ® 4 or later CPU that
supports the Enhanced Intel ® SpeedStep ® Technology (EIST).
Intel ® .SpeedStep ® .Technology.[Enabled]
Allows you to use the Enhanced Intel ® SpeedStep ® Technology. When set to [Enabled], you
can adjust the system power settings in the operating system to use the EIST feature. Set
this item to [Disabled] if you do not want to use the EIST.
Configuration options: [Enabled] [Disabled]
2.5.2. Chipset
The Chipset menu allows you to change the advanced chipset settings. Select an item then
press to display the sub-menu.
North Bridge Configuration
Memory.Remap.Feature.[Enabled]
Allows you to enabled or disable the remapping of the overlapped PCI memory above the
total physical memory. Enable this option only when you install 64-bit operating system.
Configuration options: [Disabled] [Enabled]
Memory.Hole.[Disabled]
Allows you to configure the memory hole. Configuration options: [Disabled] [15MB-16MB]
Initiate.Graphic.Adapter.[PEG/PCI]
Allows you to decide which graphics controller to use as the primary boot device.
Configuration options: [PCI/PEG] [PEG/PCI]
2.5.3 Onboard Devices Configuration
High Definition Audio [Enabled]
Allows you to enable or disable the High Definition Audio. The following item appears only
when you enable this item. Configuration options: [Enabled] [Disabled]
Front Panel Type [HD Audio]
Allows you to set the front panel audio connector (AAFP) mode to legacy AC’97 or
high-definition audio depending on the audio standard that the front panel audio
module supports. Configuration options: [AC97] [HD Audio]
Marvell.IDE.controller.[Enabled].
Allows you to disable or enable the onboard Marvell ® IDE controller.
Configuration options: [Enabled] [Disabled]
Onboard.PCIE.GbE.LAN.[Enabled]
Configuration options: [Enabled] [Disabled]