Asus P5Q SE2 - Manual (Page 30)

1-20 Chapter 1: Product introduction
Audio 2, 4, 6, or 8-channel configuration
Port
Headset.
2-channel
4-channel 6-channel 8-channel
Light Blue Line In Line In Line In Line In
Lime Line Out Front Speaker Out Front Speaker Out Front Speaker Out
Pink Mic In Mic In Mic In Mic In
Orange – – Center/Subwoofer Center/Subwoofer
Black – Rear Speaker Out Rear Speaker Ou Rear Speaker Out
Gray – – – Side Speaker Out
9.. USB.2.0.ports.1.and.2. These two 4-pin Universal Serial Bus (USB) ports are
available for connecting USB 2.0 devices.
10. USB.2.0.ports.3.and.4. These two 4-pin Universal Serial Bus (USB) ports are
available for connecting USB 2.0 devices.
11. Coaxial.S/PDIF.Out.port..This port connects an external audio output device via a
coaxial S/PDIF cable.
12.. USB.2.0.ports.5.and.6. These two 4-pin Universal Serial Bus (USB) ports are
available for connecting USB 2.0 devices.
13.. PS/2.keyboard.port.(purple). This port is for a PS/2 keyboard.
1.10.2. Internal.connectors
1.. Floppy.disk.drive.connector.(34-1.pin.FLOPPY)
This connector is for the floppy disk drive (FDD) signal cable. Insert one end of the
cable to this connector, then connect the other end to the signal connector at the back
of the floppy disk drive.
• Pin 5 on the connector is removed to prevent incorrect cable connection when using a
FDD cable with a covered Pin 5.
• The FDD cable is purchased separately.
P5Q SE2
FLOPPY
NOTE:Orient the red markings
on the floppy ribbon cable to PIN 1.
PIN1
P5Q SE2 Floppy disk drive connector