Asus P5Q SE2 - Manual (Page 42)

2-4 Chapter 2: BIOS setup
ASUSTek EZ Flash 2 BIOS ROM Utility V3.24
Current ROM Update ROM
A:
Note
FLASH TYPE: MXIC 25L8005
PATH: A:\
BOARD: P5Q SE2
VER: 0304 (H:00 B:00)
DATE: 09/01/2008
BOARD: Unknown
VER: Unknown
DATE: Unknown
[Enter] Select or Load [Tab] Switch [V] Drive Info
[Up/Down/Home/End] Move [B] Backup [ESC] Exit
(2) Insert the floppy disk or USB flash disk that contains the BIOS file into the floppy
disk drive or a USB port.
Press during POST to enter the BIOS setup utility. Go to the Tools menu,
then select EZ.Flash.2 and press .
Press to locate the correct file. Then press .
4. When the correct BIOS file is found, EZ Flash 2 performs the BIOS update process
and automatically reboots the system when done.
• This function can support devices such as USB flash disks and floppys disk with FAT.
32/16.format and single partition only.
• DO.NOT shut down or reset the system while updating the BIOS to prevent system boot
failure!
2.1.4. AFUDOS.utility
The AFUDOS utility allows you to update the BIOS file in DOS environment using a bootable
floppy disk with the updated BIOS file. This utility also allows you to copy the current BIOS
file that you can use as backup when the BIOS fails or gets corrupted during the updating
process.
Copying.the.current.BIOS
To copy the current BIOS file using the AFUDOS utility:
• Ensure that the floppy disk is not write-protected and has at least 1024KB free space to
save the file.
• The BIOS screens in this section are for reference only. The actual BIOS screen
displays may not be the same as shown.
1. Copy the AFUDOS utility (afudos.exe) from the motherboard Support DVD to a
bootable floppy disk.