GE Industrial Solutions GT Series UPS (UL Listed) 208V system PDU - Manual (Page 6)

202 00021 01 5 User manual rev date 8-16--05
2.4 Installation
The unit should be installed by service personnel.
2.4.1 Before Installing the 208V PDU, reference the UPS User Manual for proper
installation and operation of the UPS system.
2.4.2 Connecting the PDU
1. Insure that the UPS Output is off before installing the PDU. (Remember, the UPS
output may still be LIVE even when disconnected from utility power) refer to the
UPS User Manual for procedure to turn off all outputs.
2. Install the PDU and UPS units on the GT Tray with the PDU on the right hand side of
the UPS when facing the units. (as shown in Fig. 1 below)
IMPORTANT:
Insure that the ventilation openings on the left side of the UPS and the right side of the
PDU are always open and free from obstruction.
3. Plug the PDU 208VAC input plug into the locking 208VAC output receptacle of the
UPS and twist to lock. (see Fig. 1 Rear View)
UPS
PDU
PDU UPS
Fig. 1
UPS UPS
PDU PDU
PDU UPS
Fig. 1
Front View Rear View