Universal Audio Apollo Software - Manual (Page 60)

Apollo Software Manual Chapter 3: Console Application 60
Interface Settings Panel
The Interface panel is used to configure Apollo’s system-level audio interface I/O settings
such as sample rate, clock source, and output reference levels. These settings are used
by host applications when they are configured to use Apollo as the audio interface. Even
when Console is not open, these settings are stored by the Apollo drivers and will be used
by other host applications.
The Interface panel within the Console Settings window
Unit Selection
Tip: The Unit Selection functions can also be performed in the Console Mixer by
right-clicking the Unit Tabs (at upper right of the Console Mixer window).
Select Unit
This menu specifies the unit for the Identify function (see below) when multi-unit cas-
cading. Click the triangle to the right of the unit name to display the drop menu and
select a different unit. This feature is only applicable when using a supported multi-unit
configuration.
Rename Unit
The default unit name can be changed. To change the unit name: Click the unit name
field, enter the new name, then click outside the field or press return on the computer
keyboard.
Note: Text in this field is red when Apollo is not detected.
Identify
Clicking the Identify button will cause the currently selected unit’s front panel LEDs to
flash in a pattern. This identifies the unit that is currently being controlled by Console
(the current unit is changed with the Select Unit menu).
Note: This button is red when Apollo is not detected.