OSRAM OPTOTRONIC OT EASY 60 II - Manual (Page 13)

13
OT EASY 60
IV 2009
Operation
Activating the operating modes
The lighting control mode is always active. The sequencer mode and daylight simula-
tion are activated via the DIP switches in the battery compartment of the remote
control.
Activated operating modes DIP switch setting
Lighting control mode only DIP switch 3 = OFF
DIP switch 4 = OFF
ON
Sequencer mode
(incl. lighting control mode) DIP switch 3 = OFF
DIP switch 4 = ON
ON
Daylight simulation
(incl. lighting control mode) DIP switch 3 = ON
DIP switch 4 = OFF
ON
Switching on and off the luminaires
2x
max
1 2 3 < 30 s
1 2 3
1 2 3
A
B
...
Via short press.
•
All LEDs: „On/Off dimming“ button.“.
•
LEDs (channels 1 to 4): “Ch1” to “Ch4” buttons.
Changing the brightness manually
2x
max
1 2 3 < 30 s
1 2 3
1 2 3
A
B
...
Via long press. Each repeated long key press causes a toggle between increased
brightness and decreased brightness.
•
All LEDs: „On/Off dimming“ button.“.
•
LEDs (channels 1 to 4): „Ch1“ to „Ch4“ buttons.
Note:
The LEDs of a group are all connected to the same output channel and therefore
have the same brightness.