Mustang Motorcycle Seats Deluxe DayTripper Solo Seat - Harley-Davidson FLHR - Manual (Page 2)

These steps are guidelines to help you install your new Mustang product. If you need
further assistance please call us at 800-243-1392, Monday through Friday 9:00 - 5:30
Eastern or send an e-mail to
[email protected] or visit our website at
www.mustangseats.com.
For care and maintenance of our seats, please go to our website under "Support".
Ref part #'s 75602, 76350, 75459, 75876, 75578, 75797, 79100, 79102, 79316, 79317
Mounting of Mustang Seat
1. Engage nose of seat, pushing seat as far forward as possible so that the mounting
holes/studs in the fender are in the middle to back edge of the slotted tabs.
2. A firm downward chop to the nose of the seat will push the seat closer to the chrome
dash.
3. Seat is spring loaded for a tight fit so the mounting tabs will be approximately 1" - 1 1/2"
above the fender.
4. The supplied nylon washers go between the mounting tabs and the fender.
5. Start one mounting bolt/nut to finger tight, do second then secure both.
6. 1997-98 models require that the black retention clip must be left in place to hold the nut
insert in fender. 1997-98 models require seat mounting bolts (Mustang part #78028) or
stock H-D.
7. On 1999-up models the studs in the fender have some movement to help with lining up
the tabs. 1999-up models require Road King seat mounting nuts (Mustang part #78032
or stock H-D). (FIG. 1)
* If there is a gap between the nose of the driver seat and the dash, be sure seat is as
far forward as possible and adjust the chrome dash. Dash is adjusted by loosening the
1/2" hex nut and phillips screw on dash. Slide dash back and retighten. On 2004 models
nose bracket on solos can be opened up approximately 1/4" for best fit.
*All wiring harnesses must be positioned on the inside of the frame rails.
Enjoy the Comfort of your new Mustang Seat!