Mustang Motorcycle Seats One-Piece Regal Duke Seat - Suzuki 700__750__800 Intruder User Manual
Mustang Motorcycle Seats For motorcycles
These steps are guidelines to help you install your new Mustang product. If you need further assistance,
please call us at 800-243-1392, Monday through Friday 9:00 - 5:30 Eastern, or send an email to
For care and maintenance of our seats, please go to our website
Ref part #75243, 75284, 75285, 75337, 75859
Mounting Suggestions:
Suzuki 700/750/800 Intruder 1985-04
& S50 2005-09
One-Piece Seat
Baseplate Features:
The one-piece, marine-grade fiberglass baseplate is a direct
replacement for the stock two-piece seat. The clip for the
electronics module is built directly into the Mustang seat.
Rubber bumpers are positioned to protect the frame and
fender.
Stock Seat Removal Steps
1. Remove both side covers.
2. Remove the two 5 mm Allen bolts at front of the solo.
3. Lift solo up and forward.
4. Remove the two 10 mm bolts holding the solo bracket and passenger seat to the fender.
The electronics module is attached to the passenger seat. Carefully slide passenger seat
forward and up off bike.
5. Carefully remove electronics module from passenger seat.
NOTE: Put the solo bracket bolts
back into the fender with wires on the outside of the bolts.
Enjoy the Comfort of your new Mustang Seat!
Mounting of Mustang Seat
1. Clip electronics module to baseplate of seat.
2. Engage rear bracket on seat into receiver on fender.
3. Install two stock 5 mm Allen bolts on each side of seat.
4. Install side covers.