Mustang Motorcycle Seats One-Piece Deluxe DayTripper Seat for 4.5 gallon tank - Harley-Davidson XL Sportster - Manual

These steps are guidelines to help you install your new Mustang product.
If you need
further assistance please call us at 800-243-1392, Monday through
Friday 9:00 - 5:30 Eastern or send an e-mail to [email protected]
or visit our website at www.mustangseats.com.
For care and maintenance of our seats, please go to our website under "Support".
Refers to part numbers: 76140, 76141, 76144, 76145, 76146, 76147,
76374, 76375, 75543, 75544, 76142, 76143, 76290
Mounting Suggestions:
Harley-Davidson® Sportster 2004 - 2013
One-Piece Seat
Tools Required:
Phillips Screwdriver
Hardware:
Stock 1/4-20 Rear Fender Screw
Baseplate Features:
The one-piece marine grade fiberglass baseplate
mounts using the stock rear fender screw. Vibration is
minimized with the strategic placement of rubber
bumpers.
Stock Seat Removal Steps
1. Remove the rear 1/4-20 fender screw with Phillips
screwdriver and set aside. The stock rear fender screw
will be used to attach your new Mustang One-Piece
Seat.
2. Lift back of seat up about 1" then push seat forward until
the slotted center of the seat releases from the frame's
shoulder bolt. (Fig. I)
Fig. I
Mounting of Mustang Seat
1. Engage nose bracket into the frame at the base of the fuel
tank, just like the stock seat. (Fig. II)
2. Secure rear of seat to the fender with stock 1/4-20 fender
screw to complete the installation process. Note: The
Mustang Seat does not utilize the frame
ʼ s shoulder bolt.
Fig. II
Enjoy the Comfort of your new Mustang Seat!
Updated 10/11/10 AA