Mustang Motorcycle Seats One-Piece DayTripper Seat - Harley-Davidson XL Sportster - Manual

Mounting Suggestions
Harley-Davidson® Sportster 1979-2003
One-Piece Seat
Tools Required:
• Phillips Screwdriver
Hardware:
• Stock Rear Fender Screw
• Nylon Washer x1
(Included w/ 1996-03 Seat Only)
Baseplate Features:
The one-piece, 16 gauge steel baseplates are black epoxy powder coated on both sides for
complete rust proofing. Carpet protects fender paint. Polyurethane bumpers are strategically
located and riveted to the baseplate to prevent the baseplate from touching the frame and
fender and to minimize vibration. The edges of all baseplates have a steel reinforced, impact
absorbing vinyl edge trim to protect the seat cover.
Exposed brackets are bright chrome plated.
The nose tab on the baseplate for the 1982-95 883,1000, and 1200 XL models is 1” further back
than that on the 1979-81 baseplate.
The nose on the 1996-03 XL baseplate is shortened to allow room for the 3.3 gallon fuel tank
and will also fit 1983-85 XLS Roadster models.
1. Remove rear fender screw located behind the passenger seat and
set aside. The stock rear fender screw will be used to attach your
new Mustang One-Piece Seat.
2. Slide seat back and lift up
to remove
.
1979-81 XL, XLH and XLS Models
1982-95 883, 1000
a
nd 1200 XL Models
1996-03 XL and all models with a 3.3 Gallon Fuel Tank
Stock One-Piece Seat Removal Steps
updated 10/11/10 AA