Mustang Motorcycle Seats One-Piece Studded LowDown Touring Seat, Harley-Davidson Road King, FLHT, FLTR, FLHX - Manual

Mounting Suggestions
Harley-Davidson® 2008-2013 FL Touring
One-Piece Seat
Tools Required:
• Phillips Screwdriver
Hardware:
• Stock Rear Fender Screw
Baseplate Features:
One-piece touring seats are constructed on a marine-grade fiberglass baseplate
.
Stock Two-Piece Seat Removal Steps
1. Remove the rear fender screw. This screw will be used later to secure
your new Mustang One-Piece Seat.
2. Slide the passenger seat back and up.
3. Remove the solo mounting nuts located at the back of the solo seat.
Stock Solo Seat Removal Steps
1. Remove the solo mounting nuts located at the back of the solo seat.
2. Slide the solo back and up.
Stock One-Piece Seat Removal Steps
1. Remove the rear fender screw. This screw will be used later to secure
your new Mustang One-Piece Seat.
2. Remove hand strap that is secured to the motorcycle on each side of
the seat where the front saddle bag mount is located.
3. Slide the seat back and up.
Note: Certain seats will not work with H-D® or Mustang Driver
Backrest Kits. Receiver for Mustang Driver Backrest is built into the
seat; Mustang's Driver Backrest pad and post can be purchased
later if desired. (see listing on last page)