Mustang Motorcycle Seats Cyclone Frame Mounting Plate 2008 ONLY Road King FLHT & FLTR and FLHX Street Glide - Manual

Page 1 of 3
Hardware Included:
(2) Chrome Washers
(1) ¾” Plastic Spacers
(2) Chrome Acorn Nuts (1) 1/2” Plastic Spacers
(2) Black Rubber Washers (2) Hex Bolts ¼”‐20x3/4” Long
(1) 1/4‐20 x 2” Long Hex Bolt
Install the 2” long bolt
through the front mount‐
ing bracket (carpet side).
Now place the 3/4” long
bolts with washers
through the frame
mounting plate’s center
holes, hold them in place
with the rubber washers.
Mounting Suggestions
Harley-Davidson® FLHT, FLHX, FLTR 2008 ONLY
Cyclone Solo Seat and Frame Mounting Plate
Flip the frame mounting plate over,
place both plastic spacers onto the
front 2” bolt. Now thread the front
bolt into the 2nd hole in the front of
the Cyclone Solo seat, but do not
tighten. Align the two rear 3/4”
bolts with the seat’s rear threaded
inserts. Now tighten all three bolts
with a 7/16” wrench.
The Cyclone Solo seat can be positioned 1” further back on the frame mounting plate
by drilling the two indented marks in the frame mounting plate with a 5/16” drill.