Mustang Motorcycle Seats Cyclone Frame Mounting Plate 2006-2013 FLSTSB Cross Bones, FXSTC Custom, FXSTB Night Train & FXST Standard - Manual

Mounting Suggestions
Harley‐Davidson® 2006‐201ϯ Wide Tire Softail
(Will not fit on Softail Fatboy)
2006‐201ϯ SoftailCrossbones
2006‐201ϯ SoftailCustom
2006‐201ϯ SoftailNight TrĂiŶ
Cyclone Solo Seat and Frame Mounting Plate
Installation Hardware Included:
(1) nose bracket #B30126 (2) black rubber washers
(1) ¼‐20 x 1 ½” long hex head bolt (1) black plastic washer
(1) ¼‐20 x ½” long Phillips truss head screw (5) ¼ flat washers
(1) ¾” thick plastic spacer (2) ¼‐20 x 1 ½” long Phillips truss head screws
(2) ¼‐20 flange nuts (1) ¼‐20 threaded stud
(2) ¼‐20 x ¾” long Phillips truss head screw (1) chrome washer
(2) rubber bumpers (1) ¼‐20 chrome acorn nut
Attach Mustang Cyclone Solo seat to Frame Mounting Plate
1. Attach nose bracket #B30126 to bottom of frame mounting plate. Insert the ¼‐20 x ½” long Phil‐
lips truss head screw from the top side, through the nose bracket, and secure with the ¼‐20 flange
nut.
2. Align three threaded inserts in bottom of solo seat with three holes in frame mounting plate.
3. At nose end, insert the ¼‐20 x 1 ½” long hex head bolt with washer up through the nose bracket
and frame mounting plate, through the ¾” thick plastic spacer and into threaded insert in nose of
seat.
4. At back end of seat, insert the two ¼‐20 x ¾” long Phillips truss head screws with washers up
through the frame mounting plate, through the two flat black rubber washers and into the two
threaded inserts in the bottom of the seat. Tighten all three fasteners.
5. If the solo seat will be used in the rearmost mounting position, two 5/16 holes must be drilled
through the frame mounting plate at the indicated points. The two rear fasteners will be the ¼‐20 x
1 ½” long Phillips truss head screws with washers and the two 5/8” thick rubber bumpers.