Appendix c: troubleshooting, C.1 on/off of hardware flow control – SENA Parani10 User Manual
Page 47

47
2.2.7.2. TUV - CE : EN60950
2.2.7.3. ek-mark : K60950
2.2.7.4. CB / QAS / CCIB / PSE
2.3.
GENERAL CHARACTERISTICS
2.3.1
OPERATING TEMPERATURE RANGE: 0’C to 35’C at 100% Load condition.
0’C to 40’C at 90% Load condition.
2.3.2.
OPERATING HUMIDITY: 15 to 80% RELATIVE HUMIDITY
2.3.3.
STORAGE TEMPERATURE: -20’C to 85’C
2.3.4.
STORAGE HUMIDITY: 90 % RELATIVE
2.3.5.
BURN-IN PROCESS
2.3.5.1. All unit shall be subjected to burn-in process of mass production.
2.3.5.2. TEMPERATURE: 30 +/-5’C
2.3.5.3. LOAD CONDITION: 2 A
2.3.5.4. INPUT VOLTAGE: 110 / 220 Vac
3.
MECHANICAL CHARACTERISTICS
3.1.
DIMENSIONAL SIZE
LENGTH: 66 mm
WIDTH: 48.5 mm
HIGHT: 35 mm
3.2.
OUTPUT CABLE
CABLE LENGTH : 1850 +/- 50
Appendix C: Troubleshooting
C.1 ON/OFF of Hardware Flow Control
Parani10 is designed to use CTS/RTS for handshaking.
For equipment that is not using
Hardware flow control for serial communications, Parani10’s firmware should be set to turn OFF
hardware flow control (CTS/RTS).
Customers may indicate preferences when ordering or turn off the handshaking by bridging CTS
and RTS (no. 7 and no. 8 lines) using a Gender changer.
Parani10 has automatic detection feature of hardware flow control, but in certain environment
such as PC, this function may not operate correctly.