At+btlpm,n Page 39: At+btfp,n
Page 39: At+btfp,n
39
Description :
When you enter this AT commands at a host terminal, your PARANI10 returns
its device information and status to a host. It encompasses BD_ADDR, user
friendly name, operating mode, operating status and authentication/encryption
status. Especially when the operating status is PENDING, it means your
PARANI10 is busy in processing ‘AT+BTINQ?’, ‘ATD’or ‘AT_BTSCAN’. When
Authentication
or
Encryption
feature
is
activated,
the
corresponding
parameter has value of
‘1’.
AT+BTLPM,n
Function :
Set Bluetooth Low power consumption mode.
Response :
Description :
To minimize power consumption, your PARANI10 supports Bluetooth PARK
mode. When you set n as 1, your PARANI10 uses PARK mode. Using PARK
mode might cause extra data transmission delay in some cases.
AT+BTSD?
Function :
Return the list of secured devices.
Response :
…
Description :
Your PARANI10 can pair up to 5 Bluetooth devices. Upon receiving this AT
command, your PARANI10 returns all the BD_ADDRs of the previously paired
Bluetooth devices.
AT+BTCSD
Function :
Delete the info of all the paired devices stored in your PARANI10.
Response :
Description :
This AT command just deletes the info of paired devices stored on
PARANI10’s Flash memory. To delete the same info resides on PARANI10’s
RAM, you have to do software reset or hardware reset.
AT+BTFP,n
Function :
Force your PARANI10 to generate passkey automatically.
Response :