SENA Parani10 User Manual
Page 44

44
faster.
31)
ATS10
Default 1
ATS10=1
Enabling all of the response messages- OK, CONNECT,
DISCONNECT, and ERROR.
ATS10=0
Disabling all of the response messages- OK, CONNECT,
DISCONNECT, and ERROR.
ATS10?
32)
ATS11
Enable Escape (default 1)
Escape sequence character enable change from on-line
mode to command mode. If set to ‘0’, transmission speed
can be improved.
33)
ATS12
Clear UART buffer at Disconnect. (default 0)
If set to ‘1’, when disconnected, data stored in Parani10
will be removed.
34)
ATS13
Enable CDC accept (default 0)
If set to ‘0’, Parani10 will use CDC signal to let Host know
Bluetooth connection status.
If set to ‘1’, Parani10 will accept CDC signal from other
peer (DCE-configured) Bluetooth device.
35)
ATS14
ATS14=1
communications
ATS14=0
back only.
Default value of ATS14 is 0.
36)
ATS15
ATS15=1
If users set ATS15=1, users may use DTR signal to
disconnect Bluetooth connection.
If ATS15=1, and DTR signal is changed from state ON
to OFF, your connection will be disconnected.
ATS15=0